If the opener is adjusted properly the garage door will move up and down in an even motion.
My garage door opens crooked.
By pushing the door back into position you should have made the vertical track straighten.
Garage doors which have become crooked or wonky may be suffering from jumped cables which is when one or both cables have loosened from the cable drums and started to unwind.
A garage door that s out of alignment can be very dangerous.
Regular adjustment will prevent a crooked door.
The door might be hard to open and close due to it binding.
One question some homeowners ask is why their garage door closes then immediately reverses to the open position.
It is possible that the vertical track down the side has gone out of alignment and shifted due to a slightly loose lag screw.
Why does my garage door reverse as soon as it hits the floor.
There may be a large gap of space between the stop molding and the door.
To make fine adjustments try adjusting the lifting cable instead of the spring.
Jumped cables can be caused by the door hitting an object during operation or if it has been lifted too fast while being opened manually.
Warping of the door will also cause it to run crooked and stick in the tracks.
If your garage door is closing fully and then reversing to open again then it may be due to a problem with the close limit switch.
With the door propped open take the s hook out of the support and tighten or loosen the cable as needed.
Any of these situations indicate that one or both garage door tracks need to be aligned.
Your garage door has two overhead springs some doors have the springs on the side called extension springs that are responsible for opening and closing the door.
Without proper adjustment however the unit may run along the tracks unevenly.
5adjust the lift cable.
This will cause the unit to stick.
A crooked or off balanced door.
Your garage door is likely the largest opening on your home s exterior so it s important to have the peace of mind that it is functioning properly.
In order to fix this you ll want to make small changes to the close limit setting until the door opener knows to stop once the door has reached the floor.
Push the door push the door back to adjust the door and get the center aligned again.
